Custom Forged Ross Pistons
06-14-2011, 10:01 PM
#1
Le Mans Master
Thread Starter
Member Since: Jan 2003
Location: Portland Oregon
Posts: 8,596
Likes: 0
Received 17 Likes
on
16 Posts
Custom Forged Ross Pistons
I have a set of brand new Ross 2618 custom made forged pistons for an old LT4 project that I never completed. These pistons are made for forced induction use and set up at 9.5:1 compression with a 70cc head. and set up to be at zero deck at a 9.015 deck height. Meaning you won't have to deck your block an excessive amount to get to zero deck.
They are made for a 4.030 bore, 6" rods, standard size pin. The pin material is tool steel. They have been coated with a thermal barrier, anti-friction coating on the skirts, and a oil shedding coating on the underside. The coatings alone was over $300 for the set. My cost on these pistons was over $1000 plus the cost for coatings.
These same pistons were used in a blown 383 LT4 engine making 620 rwhp with a T trim blower.
Asking $800 shipped to continental USA.
They are made for a 4.030 bore, 6" rods, standard size pin. The pin material is tool steel. They have been coated with a thermal barrier, anti-friction coating on the skirts, and a oil shedding coating on the underside. The coatings alone was over $300 for the set. My cost on these pistons was over $1000 plus the cost for coatings.
These same pistons were used in a blown 383 LT4 engine making 620 rwhp with a T trim blower.
Asking $800 shipped to continental USA.
