Windage tray, or not???
01-27-2005, 03:53 PM
#1
Burning Brakes
Thread Starter
Member Since: Feb 2001
Location: Granbury TX
Posts: 769
Likes: 0
Received 0 Likes
on
0 Posts
Windage tray, or not???
I'm building my 406 for my 87 coupe and am trying to deside weather to put a windage tray on the main stud bolts or not. I am trying to get my order in for a set of ARP main studs, and can't place the order until this decision is made.
I have included them in past engine builds but it seems to me, I've seem some negative words printed somewhere in the past 6 months or so. I just can't remember where I saw it or what exactly the problem was.
Anyone else see something about that??
What are your views?
I have included them in past engine builds but it seems to me, I've seem some negative words printed somewhere in the past 6 months or so. I just can't remember where I saw it or what exactly the problem was.
Anyone else see something about that??
What are your views?
01-27-2005, 04:58 PM
#3
Burning Brakes
Thread Starter
Member Since: Feb 2001
Location: Granbury TX
Posts: 769
Likes: 0
Received 0 Likes
on
0 Posts
Probably not much over 5 thousand. It's my daily driver. I will take a pass or two down the drag strip several times through the summer.
Like you, I've always used them in the past but, like I said, I saw some bad press on them somewhere recently.
Like you, I've always used them in the past but, like I said, I saw some bad press on them somewhere recently.