Another Outer Window Seal Question.
Thread Starter
Racer
Joined: May 2001
Posts: 378
Likes: 0
From: Dunmore, Pennsylvania
Another Outer Window Seal Question.
I am replacing the pass side outer window seal on a 91, I followed the tech tips and other posts. I have the door pannel off and the old seal removed (that was hard to get out), I have the window all the way down and am trying to install the new seal, I also loosened the two pads on the door to allow the window to move more, but it is still a tight fit, I am having a hard time getting the pad on the new seal past the window on the back side of the door (the window is below the front pad, so no problem with that one) Is there a trick to this or do I just need to work it in, I don't want to break anything.
Thanks.
Thanks.
Burning Brakes
Joined: Sep 2005
Posts: 993
Likes: 3
From: Iowa
Go ahead and remove the rear guide and that will let the window fall out of the way, (you may need to remove the middle one if your car has one). Once you do this you can get it in there and you will probably have to adjust the guides with the new seal depending on if yours had been set up with it worn. Hope this helps!
