P1-SC install instructions... help
Thread Starter
Melting Slicks
Joined: Jun 1999
Posts: 2,872
Likes: 3
From: Wilmington NC
P1-SC install instructions... help
well.. have everything here except the install manual.. it somehow over the last 2 years wandered off never to be found again. at any rate I have everythign layed out on the counter in the garage and it looks very complete less the air filter which we think was left out of the kit.. not big deal as a K&N from a local shop can be found that will work. but the instructions for all the hardware and lines and routing etc would be nice to have to keep me from holding and staring at parts and having to figure out where they go.. it looks pretty simple and I think I can do it from a few pictures that I have found on the web, but again.. instructions may help in the long run.. where does the MAF go.. do not see it in any pictures is it a draw through style on the ATI kit?
this is for the 94-96 LT1 vette.. any help appreciated!
CHris
this is for the 94-96 LT1 vette.. any help appreciated!
CHris
Thread Starter
Melting Slicks
Joined: Jun 1999
Posts: 2,872
Likes: 3
From: Wilmington NC
thanks trog.. I have the car torn down to the point the supercharger is ready to go in and was hoping someone may have a copy via PDF or other perhaps that they could even fax me? I wanna get this thing finished up!
thanks in advance!
Chris
thanks in advance!
Chris
Thread Starter
Melting Slicks
Joined: Jun 1999
Posts: 2,872
Likes: 3
From: Wilmington NC
ha ha ha.. all dressed up and no manual.. there are quite a few parts here and I suppose I am doing an alright job at reverse engineering the many hoses and brackets.. the charger goes in the center console between the seats right? and I am not sure where these muffler bearings go either... I need a book STAT!! any help please!!!!!!!!!!!!!!!!
Chris
Chris
Drifting
Joined: Oct 1999
Posts: 1,338
Likes: 0
From: Raleigh, NC
NC Events Coordinator
Originally Posted by lcvette
the charger goes in the center console between the seats right? and I am not sure where these muffler bearings go either... I need a book STAT!! any help please!!!!!!!!!
Don't sweat over any extra parts left over. Slap a few PC stickers on, that'll more than make up for any install blunders. Btw, Thigpen said he's about to roll over there(I may be too, later). Just look at the SC on his stang, do everything in opposite fashion, and you got yourself a Chevy install.
Thread Starter
Melting Slicks
Joined: Jun 1999
Posts: 2,872
Likes: 3
From: Wilmington NC
anyone have a copy they would be willing to fax me? I would be more then happy to paypal for time and phone bill for LD faxing.. I really want to get this thing put in tomorrow and am at a loss..
thanks in advance!
Chris
thanks in advance!
Chris
