Fuel Pump Installation
Thread Starter
Drifting
Joined: Dec 2005
Posts: 1,309
Likes: 20
From: Woodstock Georgia
Fuel Pump Installation
Anyone have a good resource for a fuel pump swap? I bought the pump used with a blower kit, and there aren't any instructions for the pump installation.
Le Mans Master
Joined: Feb 2006
Posts: 8,753
Likes: 9
From: Louisiana
Originally Posted by silver86
Anyone have a good resource for a fuel pump swap? I bought the pump used with a blower kit, and there aren't any instructions for the pump installation.
Le Mans Master
Joined: Jan 2003
Posts: 5,858
Likes: 7
From: Santa Maria CA
It's actually pretty straight foward. Remove the torx screws holding the gas lid on and remove the lid. Remove the rubber mat around the gas cap (it's probably going to tear). Blow away the dirt and debris, undo the fuel hoses, then remove the bolts. The whole thing lifts up and out from the top. If you go slow you might have a chance of saving the sealing gasket from tearing. Depending on who the pump is from, the wiring might be diffent. Just take a look at how your old one goes when you remove it. Might as well change the sock while you are in there.
Just dont light a lighter to look into your tank! 
Drifting
Joined: Mar 2002
Posts: 1,251
Likes: 2
From: Thomson Georgia
1st, blow the dust and debri away from the tank top.
Little late after you take everything loose. If you don't have an air compressor, get one of those dust blowers that you clean your keyboard with, does the trick.
Little late after you take everything loose. If you don't have an air compressor, get one of those dust blowers that you clean your keyboard with, does the trick.
