parts collection
Thread Starter
Drifting
Joined: Nov 2005
Posts: 1,361
Likes: 0
From: Downriver Mi.
parts collection
Hi to all,Started getting my parts together for my 85 non roller,here is what I have so far.
Stock 85 lower end
LT1 converted intake in the works
Bow tie #12480034 phase 3 heads 64cc 184cc runner
Comp Cams XFI camshaft hyd. 520/515 268/280 113 lobe sep.
Comp cam mag.roller rockers,comp cam mag pushrods and lifters
cloyes roller chain&gears
Planning on headers ,true duals,and a chip.I will have to run the stock 307 gears and converter for a little while,how do you guys think it will run with this set up??
Stock 85 lower end
LT1 converted intake in the works
Bow tie #12480034 phase 3 heads 64cc 184cc runner
Comp Cams XFI camshaft hyd. 520/515 268/280 113 lobe sep.
Comp cam mag.roller rockers,comp cam mag pushrods and lifters
cloyes roller chain&gears
Planning on headers ,true duals,and a chip.I will have to run the stock 307 gears and converter for a little while,how do you guys think it will run with this set up??
Last edited by MR NICE; May 31, 2006 at 04:34 PM.
What do you guys think?I can't afford to go roller on a buget,how do think it will run any HP estimates
Le Mans Master
Joined: Jun 2002
Posts: 6,097
Likes: 0
From: High Plains Drifter Fayetteville, AR
for a flat tappet motor, I'd stick with a longtube intake manifold. You won't be spinning the motor high enought to take advantage of the short runners on the LT1 manifold.
