Dyno pull today
Thread Starter
Advanced
Joined: Feb 2005
Posts: 77
Likes: 0
From: N. Tonawanda NY
Dyno pull today
We had a portable dyno at our clubs (Corvettes of Buffalo) corvette show in Western NY today. So I had to give it a go. The car pulled 236 rwhp and 340 ft lbs of torque They didn’t record the 1st run just the last 2, the third was down on hp because the car was getting hot.
The engine is stock with 94k miles and the following mods
52mm throttle body
Adj fuel pressure regulator
New Bosch fuel injectors from TPIS
New front Y pipe less the cats
High flow cat
Flowmaster force II exhaust
2200 stall converter
New street strip tranny with shift kit
I was wondering if 236 hp is at the rear wheels what would the flywheel hp be. The motor stock from the factory is rated 245 hp
Here’s the link to the video and the dyno sheet
The engine is stock with 94k miles and the following mods
52mm throttle body
Adj fuel pressure regulator
New Bosch fuel injectors from TPIS
New front Y pipe less the cats
High flow cat
Flowmaster force II exhaust
2200 stall converter
New street strip tranny with shift kit
I was wondering if 236 hp is at the rear wheels what would the flywheel hp be. The motor stock from the factory is rated 245 hp
Here’s the link to the video and the dyno sheet
Team Owner
Joined: Sep 2001
Posts: 62,154
Likes: 1,731
From: Athens AL
C7 of the Year - Unmodified Finalist 2021
C4 of Year Finalist (performance mods) 2019
That figures to about 285-290 at the crank using a 18% drivetrain loss from the automatic, the torque number is going to be screwy since its got a higher stall TC.
