Headlight Motor-Bushing Position-Replacement Question
Thread Starter
Pro
Joined: Mar 1999
Posts: 532
Likes: 0
From: Cleveland Ohio
Headlight Motor-Bushing Position-Replacement Question
I'm wondering which way the new bushings are placed in the gear or does it matter? The ones I recieved from Mid America are undercut about a 1/16 at one end only. Do you place the undercut side down, up, doesn't matter?
Melting Slicks
Joined: May 2001
Posts: 2,161
Likes: 0
From: Tyler TX
Re: Headlight Motor-Bushing Position-Replacement Question (Frank C)
I don't think it matters. I don't remember mine being radiused at one end though (got mine from Ecklers). I just put the three bushings in, put the cover back on and everythign worked fine.
Le Mans Master
Joined: Mar 2001
Posts: 7,999
Likes: 14
From: Life is just one big track event. Everything before and after is prep and warm-up and cool-down laps
Cruise-In III Veteran
Cruise-In IV Veteran
St. Jude Donor '12
Re: Headlight Motor-Bushing Position-Replacement Question (Frank C)
It didn't matter when I did mine a couple of months ago.
