Hurst Shifter install question?
Thread Starter
Drifting
Joined: Aug 2001
Posts: 1,606
Likes: 14
From: Vacaville, CA
Hurst Shifter install question?
I am attempting to re-install and the coneccting pin won't seat itself completly. Beated on it with a light hammer and a drift and there's still about 1/16" of an inch sticking out.
Should I hit it harder with a small mini-sledge or grind off with a Dremel???
Thanks!
Should I hit it harder with a small mini-sledge or grind off with a Dremel???
Thanks!
Race Director
Joined: Feb 2003
Posts: 11,672
Likes: 20
From: Lake Wylie SC
Don't wack it too hard. I'd take it back out and try to line the holes a little better and maybe round the edges of the end of the pin you are driving in. You'll get it. Boy are you going to love it when you're done.
