Radiator Question
Thread Starter
Melting Slicks
Joined: Feb 2006
Posts: 2,938
Likes: 62
From: Columbia SC
Radiator Question
96 LT1 vert. I am getting ready to remove the radiator to do some general maintenance, upper/lower hose and I am going to backflush the radiator. My queston is - when I remove the transmission cooler lines do I have to worry about purging the system upon reinstalling the trans cooler lines? I could not find anything in the FSM that spoke about this so I just wanted some feedback. Do I just reconnect the lines and am ready to go or do I have to bleed the system like the cooling system? Thanks in advance. 
Melting Slicks
Joined: Dec 2004
Posts: 3,285
Likes: 52
From: Jacksonville, FL
St. Jude Donor '08 thru '26
No worries about the trans lines getting air. It will "self bleed" any air in the system same as when you do the screen change. Just don't forget that you need to chect the stick to see how much fluid you lost while the rad was out and refill it.
Tom
Forgot this, I use rubber fuel hose w/ bolts at one end to slip on the trans lines so I don't get a mess while the lines are off.
Tom
Forgot this, I use rubber fuel hose w/ bolts at one end to slip on the trans lines so I don't get a mess while the lines are off.
