Scan on 96 LT1
Thread Starter
Instructor
Joined: Oct 2007
Posts: 151
Likes: 1
Scan on 96 LT1
I ahve a problem with hesitation on acceleration. I have replaced the TPS. This didn't help. I did scan the engine and ont thing didn't look correct.
If i slowly push the accelerator pedal, The TPS signal (0 to 100%) looks ok however, If i push hard on the acc. the signal from the TPS (0to100% ) rizes very slowly....If i jam the acc. pedal the feedback from the scanner takes over 1 sec to indicate 100% throttle
Is this normal ?
Thanks
If i slowly push the accelerator pedal, The TPS signal (0 to 100%) looks ok however, If i push hard on the acc. the signal from the TPS (0to100% ) rizes very slowly....If i jam the acc. pedal the feedback from the scanner takes over 1 sec to indicate 100% throttle
Is this normal ?
Thanks
