PKE doesn't work
Thread Starter
Racer
Joined: Apr 2006
Posts: 279
Likes: 0
From: Maryville Tennessee
PKE doesn't work
I replaced the battery on the key fob, but when I try to program it, the PKE light on the dash won't flash when I do the steps in the manual. It just stays lit no matter what. Could it be a fuse problem? I also tried to turn on the PKE system just in case it was off, but that didn't do anything either. Any suggestions? It's not a big deal, but I would like to fix it if possible. Thanks in advance.
----------------
Now playing: Disturbed - Droppin' Plates
via FoxyTunes
----------------
Now playing: Disturbed - Droppin' Plates
via FoxyTunes
Le Mans Master
Joined: Dec 2004
Posts: 5,789
Likes: 8
From: Myrtle Beach SC
St. Jude Donor '05-'06
Melting Slicks
Joined: May 2007
Posts: 2,075
Likes: 109
From: Longmont Co
Le Mans Master
Joined: Jan 2006
Posts: 5,621
Likes: 206
From: Orlando FL
Does your PKE lamp on the DIP (light panel) light for the 2 second test when the key is turned to ON. Did it ever light for the for the self test.
If the fuses are good and the PKE does not light, then it is in sleep mode or the PKE receiver might be bad. But even in sleep mode if the receiver is good, you should be able to get the lamp to light when going into programming mode.
If the fuses are good and the PKE does not light, then it is in sleep mode or the PKE receiver might be bad. But even in sleep mode if the receiver is good, you should be able to get the lamp to light when going into programming mode.
Melting Slicks
Joined: May 2007
Posts: 2,075
Likes: 109
From: Longmont Co
Does your PKE lamp on the DIP (light panel) light for the 2 second test when the key is turned to ON. Did it ever light for the for the self test.
If the fuses are good and the PKE does not light, then it is in sleep mode or the PKE receiver might be bad. But even in sleep mode if the receiver is good, you should be able to get the lamp to light when going into programming mode.
If the fuses are good and the PKE does not light, then it is in sleep mode or the PKE receiver might be bad. But even in sleep mode if the receiver is good, you should be able to get the lamp to light when going into programming mode.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
8th Gear
Joined: Nov 2011
Posts: 8
Likes: 0
Thanks to all that replied. It turned out that I have a lot of slop in my ignition switch. Switching the key to the off position would just turn off the PKE light and it would not begin flashing. If I turned off the key, but kept the key firmly pushed in, it would begin flashing. Then I could get someone to bring the fob in range. letting go of the key would kill the connection. Thanks again.
Le Mans Master
Joined: Jan 2006
Posts: 5,621
Likes: 206
From: Orlando FL
Thanks to all that replied. It turned out that I have a lot of slop in my ignition switch. Switching the key to the off position would just turn off the PKE light and it would not begin flashing. If I turned off the key, but kept the key firmly pushed in, it would begin flashing. Then I could get someone to bring the fob in range. letting go of the key would kill the connection. Thanks again.
These probelms are definitly in the "age"category.
Our older cars are wearing.
