ABS question on an 86
Thread Starter
Advanced
Joined: Nov 2005
Posts: 92
Likes: 0
ABS question on an 86
I know nothing of ABS, other than 86 was the first year for it. I noticed as I was cleaning crud off my control arms and bearrings, the ABS line going to the sensor in the hub (not sure I'm saying that right), is all cracked. Well the sheething is. It's brittle and falling apart, exposing the 2 shielded wires beneith? I must admit, I haven't really looked into this much, but can I replace these lines? I did a fast search and haven't found ABS sensor lines. I'm guessing the cracked sheething is just age. Any of this making sense? any ideas?
Team Owner
Joined: Jan 2003
Posts: 20,306
Likes: 242
From: Summerland B.C. Canada
As far as I know, the sensor with wiring, is discontinued. Maybe you can unplug the sensor further down the line, remove the wires from the connector and slide some shrink tube over the wiring.
Or just tape the exposed section and call it a day.
Or just tape the exposed section and call it a day.
