Midplate for Dana 44 Centersection
Thread Starter
Melting Slicks
Joined: Nov 2008
Posts: 2,765
Likes: 5
Midplate for Dana 44 Centersection
Does anyone know who makes the Mid-plate for the Dana 44 to reinforce the Aluminum Center section ?
I seen a Dana 44 Mid-plate on E bay a few months back. The seller quit selling there.
Was made out of aircraft grade aluminum and cut on a water jet table.
The mid-plate also allowed the use of a standard Dana 36 Batwing Cover on a Dana 44 after drilling the needed mounting holes.
Wish to purchase this mid-plate if I can reach this seller.
Thanks, BR.
I seen a Dana 44 Mid-plate on E bay a few months back. The seller quit selling there.
Was made out of aircraft grade aluminum and cut on a water jet table.
The mid-plate also allowed the use of a standard Dana 36 Batwing Cover on a Dana 44 after drilling the needed mounting holes.
Wish to purchase this mid-plate if I can reach this seller.
Thanks, BR.
Last edited by 87 vette 81 big girl; May 19, 2009 at 12:32 AM.
