1990 Starter
Corvette Enthusiast
Joined: Oct 2007
Posts: 6,790
Likes: 2,697
From: So. Cal.
2025 C7 of the Year Finalist- Unmodified
2024 C7 of the Year Finalist - Unmodified
2023 C7 of the Year Finalist - Unmodified
Vette
They are not to bad. Check your local parts suppliers.
Good Luck
Corvette Mike
Good Luck
Corvette Mike
Le Mans Master
Joined: May 1999
Posts: 6,513
Likes: 1,301
From: Windermere FL
If I recall it is disconnect the battery, like two bolts and then another to get the battery cable off and I think there was a wire for the relay and it comes right off.
Personally I stear away from the big retailers because of my past experiences with their alternators. Although I have not yet yet replaced my starter, I would recommend PowerMaster based on my experience with their alternators.
One thing you can consider (especially if you have headers) is putting some of that auto heat wrap around it while you are putting it back in. Race shops should have it. Cheap ounce of prevention.
Personally I stear away from the big retailers because of my past experiences with their alternators. Although I have not yet yet replaced my starter, I would recommend PowerMaster based on my experience with their alternators.
One thing you can consider (especially if you have headers) is putting some of that auto heat wrap around it while you are putting it back in. Race shops should have it. Cheap ounce of prevention.
Safety Car
Joined: Jan 2004
Posts: 3,783
Likes: 15
From: Northern California
The Nippondenso mini starter from Napa is what I used. It's the same starter that GM used.
The two transmission cooler lines will be in the way but, with a lot of patience and manuvering the starter can be removed and replaced within an hour.
The two transmission cooler lines will be in the way but, with a lot of patience and manuvering the starter can be removed and replaced within an hour.
Last edited by GKK; Jan 24, 2010 at 10:24 PM.
