L98 valve cover paint
#22
Intermediate
Member Since: Sep 2010
Location: LaVale Maryland
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
#23
Melting Slicks
Plenum and runners, just soaked & cleaned with mineral spirits.
Valve covers, soaked & cleaned with mineral spirits and a wire brush that looks like a tooth brush. Followed up with engine cleaner. You could use engine cleaner on all 3 if you like.
Valve covers, soaked & cleaned with mineral spirits and a wire brush that looks like a tooth brush. Followed up with engine cleaner. You could use engine cleaner on all 3 if you like.
#24
HAD2HAV2 is there any chance you have the runners on the wrong sides?
#25
Melting Slicks
Placement is correct. Small tube is for the Cold Start injector. The other side does not have one. I had the Runners ported and so when I was doing a test fit I had to scratch my head to remember which side went where. The little tube gave it away. Funny, corvetteronw's little tube is on the driver side. Mine is a 88.