Mini ram mat sensor?
Burning Brakes
Joined: May 2004
Posts: 1,230
Likes: 27
From: Athens Ohio
The only relocation I did was to lay it on the lower part of the manifold. I secured it with a plastic tie. It's been like that for two years. I figure it's getting a more accurate temp reading there, then located in the air intake housing. Of course I don't have a air intake housing since I'm supercharged.
I have never had a problem.
I have never had a problem.
Race Director
Joined: Jun 2004
Posts: 13,969
Likes: 710
From: WI
I put mine in the air filter housing. Use a drill just slightly smaller than the sensor. This way the sensor will cut some threads as it screws in. I also put some glue on it and extended the wire.
