Thread size for steering wheel puller?
Thread Starter
Le Mans Master
Joined: Dec 2002
Posts: 5,270
Likes: 3
From: Seattle Area WA
Thread size for steering wheel puller?
My steering wheel puller doesn't have the right screws to bolt into the wheel, I know it is a long shot, but does anybody know what size thread they are?
I can't imagine using hook bolts as it could only grab plastic and it will break it. Worst case I'll buy a bunch of screws but I'm hoping somebody here knows.
Thanks in advance!
I can't imagine using hook bolts as it could only grab plastic and it will break it. Worst case I'll buy a bunch of screws but I'm hoping somebody here knows.
Thanks in advance!
Thread Starter
Le Mans Master
Joined: Dec 2002
Posts: 5,270
Likes: 3
From: Seattle Area WA
Ok, didn't have one in the garage so bought a bag full of bolts from Ace, the winner is:
5/16-18, I used a pair of 4" bolts. About $1 from Ace for those two.
My puller, rented from O'Reilly's Auto only had 5/16-24...and they were too short anyway.
5/16-18, I used a pair of 4" bolts. About $1 from Ace for those two.
My puller, rented from O'Reilly's Auto only had 5/16-24...and they were too short anyway.
