Fuel cell?????
Thread Starter
Team Owner
Joined: Nov 1999
Posts: 32,782
Likes: 11
From: Former NCM Drag Racing coordinator, National director Corvette Challenge Spring Hill, Tennessee: Whiting, New Jersey
Cruise-In VI Veteran
Cruise-In VII Veteran
Fuel cell?????
Anyone have a 8 gal in a C4????????????
PITA OR WHAT?????
PITA OR WHAT?????
Team Owner
Joined: Mar 2001
Posts: 30,858
Likes: 293
From: Boston, Dallas, Detroit, SoCal, back to Boston MA
Re: Fuel cell????? (mackeyred96)
www.exoticmuscle.com will install one in your stock tank.
You'll never notice it was there! :yesnod:
You'll never notice it was there! :yesnod:
Thread Starter
Team Owner
Joined: Nov 1999
Posts: 32,782
Likes: 11
From: Former NCM Drag Racing coordinator, National director Corvette Challenge Spring Hill, Tennessee: Whiting, New Jersey
Cruise-In VI Veteran
Cruise-In VII Veteran
Re: Fuel cell????? (BrianCunningham)
Brian, the hole Idea is to get rid of the big tank and have all the fuel in a smaller container to prevent starvation.
Team Owner
Joined: Mar 2001
Posts: 30,858
Likes: 293
From: Boston, Dallas, Detroit, SoCal, back to Boston MA
Re: Fuel cell????? (mackeyred96)
They put a foam core into it, that may do what you want.
It not, why not just redo the pickup point?
You can see the bottom of the tank once the spare is out.
Leave the gage where it's at.
put a new pickup at the back and bottom.
It not, why not just redo the pickup point?
You can see the bottom of the tank once the spare is out.
Leave the gage where it's at.
put a new pickup at the back and bottom.
Race Director
Joined: Aug 2000
Posts: 14,130
Likes: 7
Cruise-In II Veteran
Re: Fuel cell????? (mackeyred96)
mackey,
The only PITA is removing the rear bumper cover,rear exhaust and dropping down the rear tank frame to et the old tank out.
Aside from that,dont see a problem putting a fuel cell back there.
I replaced my tank at home with a new one and didnt find the job that bad.Just the bumper cover bolts were a little hard to reach.
Plenty of room in there to do so,however,ya may need to fabricate or weld a plate to secure it down to the cell is too short and would slip through the frame opening.
If you retain the stock fuel lines,you may need to fabricate or put some kind of straps in there to keep them from banging around.
GM used soft foam cushions between the tank,lines,and inside panels to keep the fuel lines steady in place back there.
:)
The only PITA is removing the rear bumper cover,rear exhaust and dropping down the rear tank frame to et the old tank out.
Aside from that,dont see a problem putting a fuel cell back there.
I replaced my tank at home with a new one and didnt find the job that bad.Just the bumper cover bolts were a little hard to reach.
Plenty of room in there to do so,however,ya may need to fabricate or weld a plate to secure it down to the cell is too short and would slip through the frame opening.
If you retain the stock fuel lines,you may need to fabricate or put some kind of straps in there to keep them from banging around.
GM used soft foam cushions between the tank,lines,and inside panels to keep the fuel lines steady in place back there.
:)
