who does good chip programming
Melting Slicks
Joined: Mar 2008
Posts: 2,141
Likes: 76
From: Santa Maria, CA
Looking at the GM prints its a normally open contack that closes on temp rise.
it ohm out at 0.3 meg ohm. That is preety much an open circut and the ECM most likey sees faint voltage to tell if its hook up. On temp rise it closes to tell the ECM the system in working, So a 12 volt relay,hi value resitor should do the trick.
I want to see if it kicks a code out anyway.
What do I do for a living, Automation, PLC's and robots
What's the best solfware to get to look at
and change the ECM ?
I want to get more into that
thanks for the help everybody
it ohm out at 0.3 meg ohm. That is preety much an open circut and the ECM most likey sees faint voltage to tell if its hook up. On temp rise it closes to tell the ECM the system in working, So a 12 volt relay,hi value resitor should do the trick.
I want to see if it kicks a code out anyway.
What do I do for a living, Automation, PLC's and robots
What's the best solfware to get to look at
and change the ECM ?I want to get more into that
thanks for the help everybody
