Problem with TunerPro RT and '93 scanning
Thread Starter
Racer
Joined: Dec 2007
Posts: 416
Likes: 3
Problem with TunerPro RT and '93 scanning
I can't find the answer.
I've had Moates APU1 forever for my truck and was surprised/excited that it can be used on my '93.
So I tried to connect to do a quick scan in the driveway using the $DA2 mask. The problem is every 30-45 seconds or so the security light will flash and the scan freezes. Then 20+ seconds later it starts again. It does this over and over.
Anyone know what needs to be done to get this to work properly?
I've had Moates APU1 forever for my truck and was surprised/excited that it can be used on my '93.
So I tried to connect to do a quick scan in the driveway using the $DA2 mask. The problem is every 30-45 seconds or so the security light will flash and the scan freezes. Then 20+ seconds later it starts again. It does this over and over.
Anyone know what needs to be done to get this to work properly?
Advanced
Joined: Feb 2014
Posts: 88
Likes: 7
It sounds like the CCM might be interfering with ALDL comms. There needs to be a silence CCM command in the adx file. On 93's the CCM is the bus master. Ask around and see if anyone has a good working file for Corvettes.
Heel & Toe
Joined: May 2014
Posts: 21
Likes: 0
I can't find the answer.
I've had Moates APU1 forever for my truck and was surprised/excited that it can be used on my '93.
So I tried to connect to do a quick scan in the driveway using the $DA2 mask. The problem is every 30-45 seconds or so the security light will flash and the scan freezes. Then 20+ seconds later it starts again. It does this over and over.
Anyone know what needs to be done to get this to work properly?
I've had Moates APU1 forever for my truck and was surprised/excited that it can be used on my '93.
So I tried to connect to do a quick scan in the driveway using the $DA2 mask. The problem is every 30-45 seconds or so the security light will flash and the scan freezes. Then 20+ seconds later it starts again. It does this over and over.
Anyone know what needs to be done to get this to work properly?
