Pillar instrument pod install
#1
Instructor
Thread Starter
Pillar instrument pod install
Hi all,
I want to add mechanical oil pressure and possibly some other gauges to the pillar of my C4. If you have done this where did you run the pipes? I have tried a few places but just cant seem to get the pipe through to somewhere where I can see it.
Thanks
Gareth
I want to add mechanical oil pressure and possibly some other gauges to the pillar of my C4. If you have done this where did you run the pipes? I have tried a few places but just cant seem to get the pipe through to somewhere where I can see it.
Thanks
Gareth
#2
Drifting
DO NOT run oil into the car.
Get an electrical sensor for in car. You can verify and compare under the hood but running oil or fuel into the car is a mistake waiting to happen.
Get an electrical sensor for in car. You can verify and compare under the hood but running oil or fuel into the car is a mistake waiting to happen.
The following users liked this post:
Gareth (10-11-2015)
#3
Melting Slicks
I'm running mechanical OP and temp in the center, where the display select panel was. On the pillar I have fuel/air and a computer.. all AutoMeter. Tis tight getting leads to the pillar.