Jacking Help
Le Mans Master
Joined: Jul 2002
Posts: 5,818
Likes: 2
From: Alive and well in Burlington NC
Re: Jacking Help (Diamond)
Burning Brakes
Joined: Jan 2000
Posts: 1,015
Likes: 3
From: Esko MN
Re: Jacking Help (Diamond)
Diamond,
I think it was Mr. Mojo who said he uses a piece of 4 X 4 under the spare tire carrier and puts the floor jack on that and jacks up the whole rear end, then places the jack stands on the frame ahead of the rear wheels in the places shown in the manual. I tried this and it works really good! A lot better than jacking up each side and trying to get a jack stand in there.
Greg
I think it was Mr. Mojo who said he uses a piece of 4 X 4 under the spare tire carrier and puts the floor jack on that and jacks up the whole rear end, then places the jack stands on the frame ahead of the rear wheels in the places shown in the manual. I tried this and it works really good! A lot better than jacking up each side and trying to get a jack stand in there.
Greg
Elite Torch Red Member
Joined: Sep 1999
Posts: 57,805
Likes: 23
From: Exit 89 GSP,Lakewood,NJ The Land Of Mojo
Cental/South NJ Events Coordinator
CI 1-2-3-4-5-6-7-8-9-10-11-12 Vet
CI-II Burnout & Drag Champ
St. Jude Donor '03-'04-'05-'06-'07
Re: Jacking Help (Greg Johnson)
Yes, I use a 4x4 to help with the jacking. But I just acquired a "jack-a-vette" which goes on your jack and fits between the exhaust pipes and lifts the car by the differential.
Elite Torch Red Member
Joined: Sep 1999
Posts: 57,805
Likes: 23
From: Exit 89 GSP,Lakewood,NJ The Land Of Mojo
Cental/South NJ Events Coordinator
CI 1-2-3-4-5-6-7-8-9-10-11-12 Vet
CI-II Burnout & Drag Champ
St. Jude Donor '03-'04-'05-'06-'07
Re: Jacking Help (Greg Johnson)
I think that's the one, but I don't know, mine was donated to me by another forum member who had it donated to him.
Le Mans Master
Joined: Jan 2002
Posts: 5,556
Likes: 0
From: Jenison MI
Cruise-In VI Veteran
Cruise-In VII Veteran
St. Jude Donor '06
Re: Jacking Help (Mr Mojo)
I think that's the one, but I don't know, mine was donated to me by another forum member who had it donated to him.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Top 10 Corvette Engines RANKED by Peak Torque (70+ Years of Muscle!)
Joe Kucinski
Corvette ZR1X Will Be Pacing the Indy 500, And Could Probably Race, Too!
Verdad Gallardo
Top 10 Corvettes Coming to Mecum Indy 2026!
Brett Foote
Top 10 C9 Corvette MUST-HAVES to Fix These C8 Generation Flaws!
Michael S. Palmer
10 Revolutionary 'Corvette Firsts' Most People Don't Know
Joe Kucinski
5 Reasons to Upgrade to an LS6-Powered Corvette; 5 Reasons to Stay LT2
Michael S. Palmer
2027 Corvette vs The World: Every C8 vs Its Closest Competitor
Joe Kucinski
10 Most Common Corvette Problems of the Last 20 Years!
Joe Kucinski
Racer
Joined: Sep 2000
Posts: 286
Likes: 0
From: St. Petersburg, FL, USA FL
Re: Jacking Help (Diamond)
A jack-a-vette is the way to go. If you can't get the floor jack under it, run the car up on some ramps, then jack it. Or alternately, if you only need a little clearance you can just drive it up on some 2 x 10's.
There is another alternative that I use. I bought an extra stock jack, and I jack both sides of the car simultaneously using the designated jacking locations. When I get it up I put the jack-a-vette into play, take the manual jacks away from the jacking locations and sub jack stands in their place.
I works real well, and I don't feel I'm risking torquing the car at all. I got the extra jack from Gene at Karshop on the forum.
There is another alternative that I use. I bought an extra stock jack, and I jack both sides of the car simultaneously using the designated jacking locations. When I get it up I put the jack-a-vette into play, take the manual jacks away from the jacking locations and sub jack stands in their place.
I works real well, and I don't feel I'm risking torquing the car at all. I got the extra jack from Gene at Karshop on the forum.
