Tach needle issue?
#1
Instructor
Thread Starter
Tach needle issue?
I have an issue with my factory tach gauge on my 94 auto. At start up it stays at zero until I hit a bump or, it just pops up to normal. So, my question is is this issue mechanical, meaning is the gauge sticking or could it be electrical?
#2
KEY-ON but NOT RUNNING where does the needle park? Does it always?
#3
Instructor
Thread Starter
#4
JUST "KEY - ON" NO CRANKING - KEY ON and make no attempt to do anything. An electronic tach should always park @ 0 when KEY ON, not higher or lower but 0
When you shut down from any RPM "KEY OFF" the needle could park "ANYWHERE"!!!!
When you shut down from any RPM "KEY OFF" the needle could park "ANYWHERE"!!!!
Last edited by WVZR-1; 08-02-2017 at 05:34 PM.