C4 door locks
Thread Starter
Cruising
Joined: Nov 2017
Posts: 13
Likes: 0
From: CT
C4 door locks
Does anyone have any ideas? While replacing my window motor on the passenger side I was taking off the door panel and went to disconnect all the switches. When I went to disconnect the power door lock switch, I must have touched the hot wire and got a little spark. Didn’t think to much about it but when I put all together, the power door locks do not work. I have gone through all the fuses and circuit breakers and all are good. Even the switches on the drivers door aren’t working. If I’m not mistaken, the orange wire is hot all the time. Any ideas where to look?
Safety Car
Joined: Aug 2013
Posts: 4,429
Likes: 605
From: Minneapolis Mn
IIRC the door locks and power seats are on the same circuit breaker in the fuse panel. Won't swear to it, but I think it's the 3d one from the top.
If the power seats work, then it likely is in the switch/door. If both are out then I'd check the circuit breaker. This is all based on my 86.
If the power seats work, then it likely is in the switch/door. If both are out then I'd check the circuit breaker. This is all based on my 86.
Last edited by hcbph; Apr 22, 2018 at 09:54 AM.
Thread Starter
Cruising
Joined: Nov 2017
Posts: 13
Likes: 0
From: CT
IIRC the door locks and power seats are on the same circuit breaker in the fuse panel. Won't swear to it, but I think it's the 3d one from the top.
If the power seats work, then it likely is in the switch/door. If both are out then I'd check the circuit breaker. This is all based on my 86.
If the power seats work, then it likely is in the switch/door. If both are out then I'd check the circuit breaker. This is all based on my 86.
