Wiring from passenger compartment to storage compartments
#1
Burning Brakes
Thread Starter
Wiring from passenger compartment to storage compartments
I need to run some wiring from the passenger compartment into the storage compartments. Can anyone confirm that there is only a single layer of sheet-metal between the passenger compartment and the storage compartments at the locations shown in red below?:
-Wes
-Wes
Last edited by LWesthaver; 09-24-2018 at 02:08 PM.
#3
Burning Brakes
Thread Starter
I'll take a look to see where the ABS wiring enters the storage compartment.
I'm mostly interested in running wires into the passenger side compartment. The drivers side compartment would be my second choice since it already contains the ABS hardware.
The wires I need to run come from the dash, run down the side of the transmission tunnel and then need to go into the passenger side storage compartment.
--Wes
I'm mostly interested in running wires into the passenger side compartment. The drivers side compartment would be my second choice since it already contains the ABS hardware.
The wires I need to run come from the dash, run down the side of the transmission tunnel and then need to go into the passenger side storage compartment.
--Wes
Last edited by LWesthaver; 09-26-2018 at 01:06 AM.
#5
Burning Brakes
Thread Starter
Last edited by LWesthaver; 08-09-2019 at 05:27 PM.
#6
Race Director
I relocated my battery back near the rear bumper. I ran the battery cables through that bulkhead. It is a thin layer.
The following users liked this post:
LWesthaver (09-29-2018)
#7
Burning Brakes
Thread Starter
#8
Burning Brakes
Thread Starter
Done!
I cut the access hole I needed and ran the wiring into the passenger side storage compartment. I punched two 7/8" holes and then cut out the metal between them to create an oval opening. Then I split some rubber hose to make a grommet. It turned out pretty nice.
#10
Burning Brakes
Thread Starter