Driveline noise after New clutch, pressure plate and flywheel,
#1
Driveline noise after New clutch, pressure plate and flywheel,
Just had a new clutch, pressure plate, flywheel, throwout bearing, slave cylinder installed. Never had any noise prior to this, now it sounds like driveline noise, like a grinding, vibrating noise mostly in 6th gear under acceleration. It is a little noticable in other lower gears, but very noticeable on acceleration in 6th. No noise on deceleration and no noise in neutral with clutch out, no noise coasting. Almost feels like not having any rubber mounts anywhere in the motor or driveline. Any ideas?
#4
Race Director
Sprung hub clutch or non sprung hub?
as with question above:
did you go dual mass or single mass?
did they balance the pressure plate to the flywheel? (This can be either good or bad depending on how they did it bc you still want to retain the external balance in same location (on the dual mass flywheel) the same as factory).
If single mass alum flywheel, and they remove the external flywheel weight , zero balance it, reinstall the weight, then its good.
as with question above:
did you go dual mass or single mass?
did they balance the pressure plate to the flywheel? (This can be either good or bad depending on how they did it bc you still want to retain the external balance in same location (on the dual mass flywheel) the same as factory).
If single mass alum flywheel, and they remove the external flywheel weight , zero balance it, reinstall the weight, then its good.