Oil Pressure Sensor/Sender Connector
Thread Starter
Burning Brakes
Joined: Apr 2007
Posts: 1,003
Likes: 13
Oil Pressure Sensor/Sender Connector
This is in regard to an '86.
I've been trying to get this car started, but have had a lot going on in life lately, and have been interrupted a lot. I was checking out the two-wire connector to the oil pressure sensor/sender, and not sure which direction it goes back on. There is a red wire, and an orange one. Can anyone tell me which direction it goes on, or have a pic of it connected?
Thank you...
I've been trying to get this car started, but have had a lot going on in life lately, and have been interrupted a lot. I was checking out the two-wire connector to the oil pressure sensor/sender, and not sure which direction it goes back on. There is a red wire, and an orange one. Can anyone tell me which direction it goes on, or have a pic of it connected?
Thank you...
Team Owner
Joined: Sep 2003
Posts: 25,398
Likes: 2,742
I'd think it's a 'normally closed' with oil pressure so I'd thing it likely doesn't matter. The 'connector' isn't indexed is it?
Try 8A-20- in the FSM.
Are the terminals A & B marked on the switch?
Try 8A-20- in the FSM.
Are the terminals A & B marked on the switch?
Last edited by WVZR-1; Sep 4, 2022 at 01:12 PM.
Pro
Joined: Feb 2009
Posts: 655
Likes: 164
From: Vancouver Washington
On my 86 vert the wires are in a push on/ squeeze off type of connector. The orange wire is towards the front of the car but I don't think that matters. Just plug it in and if it doesn't work then turn it around. Only goes on two ways.
