Codes
Thread Starter
Heel & Toe
Joined: Sep 2002
Posts: 23
Likes: 0
From: Castle Rock Wash.
Codes
I have a stalling problems I am tring to solve, the engine always starts with no problems after stalling, which happened again last night. My question today is, I checked for codes this morning and was given a code of "34", the book says this is either MAF or MAP sensors. would either one of these sensors being faulty cause staling?
Thanks
Paul
Thanks
Paul
Melting Slicks
Joined: Apr 2002
Posts: 2,118
Likes: 0
From: St. Charles, MO Route 66 Corvette Club
Re: Codes (BLESSED427)
A quick check of my Helms manual reveals that a code 34 is "a low air flow" for at least one second when the engine is first started or RPM is above 600. This suggests problems with the Mass Air Flow sensor. I would get a scan tool and check out the MAF. This puppy is not cheap! Good Luck!
Team Owner
Joined: Dec 2000
Posts: 90,675
Likes: 304
From: SE NY
Cruise-In II Veteran
Re: Codes (BLESSED427)
You have a MAF sensor.
Look into the MAF bore just after someone turns off the engine to see if the sensor wires glow red for two seconds. If not replace the burn off relay; if so replace the power relay.
Also check the IAC setting of base idle
Look into the MAF bore just after someone turns off the engine to see if the sensor wires glow red for two seconds. If not replace the burn off relay; if so replace the power relay.
Also check the IAC setting of base idle
