Burn off moduy
Thread Starter
6th Gear
Joined: Apr 2024
Posts: 6
Likes: 0
Burn off module
Hello, I have a 1985 Corvette. The car was running rough. I jumped the codes and got cold 34. The MAF sensor had a few broken wires so I replaced it. Now with the car is doing is starting and stalling it will not run. I pulled out the burn off module and opened it up and the relay is constantly clicking on and off. If I hold the relay open and start the car it runs beautiful. I want to buy a new one, but nothing is tested and I’m afraid of getting the same thing that I have. If I Cut the wire to the relay and just leave the relay open will that mess anything else up? I know it’s not correct. Thank you.
Last edited by Slow5o; Nov 14, 2025 at 05:29 PM.
Thread Starter
6th Gear
Joined: Apr 2024
Posts: 6
Likes: 0
yes, I did. I cleared the codes and then the car kept starting and stalling . But the burn off box the relay keeps clicking so I held it open and the car runs great. If I let it close it automatically stalls. I know it’s not right, but I was just gonna de pin the power wire going into it and just leave it open for now and just wanted to know if it would mess anything else up.
