Anyone using the DynaSpark from DynoTech engineering?
Thread Starter
Racer
Joined: Sep 2000
Posts: 479
Likes: 0
From: St. Petersburg Florida
CI 6-7-8-9 Veteran
Anyone using the DynaSpark from DynoTech engineering?
I've seen several threads on this product, but have yet to see any replies from someone actually using one. I'm thinking about using a Gen I when they are available. I'm going to have the front of the engine out later this year and would like to change out the opti and water pump at the same time, I'm thinking of going Mezier on the H20 setup. Since this is a (Supposedly) very well sealed unit, is there any reason to really do the full upgrade to the gen II setup with the heavy duty chain etc? This is a pleasure vehicle gets about 8,000 miles a year. All of it is street cruising.
:steering: :yesnod: :yesnod:
:steering: :yesnod: :yesnod:
Elite Torch Red Member
Joined: Sep 1999
Posts: 57,805
Likes: 23
From: Exit 89 GSP,Lakewood,NJ The Land Of Mojo
Cental/South NJ Events Coordinator
CI 1-2-3-4-5-6-7-8-9-10-11-12 Vet
CI-II Burnout & Drag Champ
St. Jude Donor '03-'04-'05-'06-'07
Re: Anyone using the DynaSpark from DynoTech engineering? (92PoloVette)
See this thread, that's what I'm doing instead.
http://forums.corvetteforum.com/zerothread?id=556294
http://forums.corvetteforum.com/zerothread?id=556294
Race Director
Joined: Feb 2003
Posts: 11,672
Likes: 20
From: Lake Wylie SC
Re: Anyone using the DynaSpark from DynoTech engineering? (Mr Mojo)
I will be watching very closely to your upgrade. This is a new approach for me. I thought the DynaSpark was the only answer to our opti problems. And I strongly agree with the Mez pump. It will be my next project when my GM pump begins to fail.
