FX3 codes
Thread Starter
Pro
Joined: Apr 2003
Posts: 712
Likes: 0
From: Memphis TN
FX3 codes
Well I finally was able to pull the codes: 14,31,32,33,and 34. 31,32,33,34 are just out of position codes and 14 is a right front inoperative. I tried to feel the motor on the left front and right front, but could not feel any movement.Am I to assume that the right front is broken and the others are out of position secondary to this? Thanks, Tom :confused:
Drifting
Joined: Aug 2000
Posts: 1,521
Likes: 0
From: West Islip New York
Re: FX3 codes (DocToss)
Well I finally was able to pull the codes: 14,31,32,33,and 34. 31,32,33,34 are just out of position codes and 14 is a right front inoperative. I tried to feel the motor on the left front and right front, but could not feel any movement.Am I to assume that the right front is broken and the others are out of position secondary to this? Thanks, Tom :confused:
Race Director
Joined: May 2000
Posts: 17,101
Likes: 5
From: No more yankee my wankee, the Donger is tired!
Re: FX3 codes (DocToss)
12 = Start of sequence
13 = Left rear time out
14 = Right Front time out
21 = Left Front time out
22 = Right Rear time out
31 = Left Front out of position
32 = Right Front out of position
33 = Left Rear out of position
34 = Right Rear out of position
Out of position codes are triggered if the computer senses that the actuator has not found the end stop position on the shock. Remove actuator at the indicated shock. Turn the valve gear on the shock stops after about 3 / 4 of turn, then you have a bad actuator. If it spins around continuously then it is a bad shock
41 = Selective ride control switch short to voltage
42 = Selective ride control switch open contacts
You can have a code 42 if you leave the switch in between indented positions
43 = selective ride control switch circuit open.
13 = Left rear time out
14 = Right Front time out
21 = Left Front time out
22 = Right Rear time out
31 = Left Front out of position
32 = Right Front out of position
33 = Left Rear out of position
34 = Right Rear out of position
Out of position codes are triggered if the computer senses that the actuator has not found the end stop position on the shock. Remove actuator at the indicated shock. Turn the valve gear on the shock stops after about 3 / 4 of turn, then you have a bad actuator. If it spins around continuously then it is a bad shock
41 = Selective ride control switch short to voltage
42 = Selective ride control switch open contacts
You can have a code 42 if you leave the switch in between indented positions
43 = selective ride control switch circuit open.
