PLUG WIRING?????????
Thread Starter
Racer
Joined: Apr 2003
Posts: 371
Likes: 0
From: Kingsport TN
PLUG WIRING?????????
REPLACING PLUG WIRES ON MY 89 WITH ACCEL 8.8's. CAN'T FIND WIRE SEPARATORS BIG ENOUGH FOR THEM. HAVE BOWTIE HEADS, NO CENTER BOLT VALVE COVERS. TIRED OF BURNING THEM ON THE HEADERS. WANT THE INSTALL TO LOOK AND FUNCTION RIGHT....NO RICE.............
THANKS FOR THE HELP YA'LL :chevy
THANKS FOR THE HELP YA'LL :chevy
Drifting
Joined: Aug 2002
Posts: 1,857
Likes: 0
From: Yakima WA
Re: PLUG WIRING????????? (justatoy)
Getting ready to do close to the same thing tomorrow w/ 8.5 mm wires. I am going to try to dremmel the looms I have to fit, but if it doesn't work out, I will order some from Summit. Good luck
Team Owner
Joined: Dec 2000
Posts: 90,675
Likes: 304
From: SE NY
Cruise-In II Veteran
Re: PLUG WIRING????????? (justatoy)
I'm using Made For You looms for the MSD 8.5mms on my IROC with headers.
You will likely need to Dremel them slightly for a good fit, but no big deal as there is plenty of material.
You will likely need to Dremel them slightly for a good fit, but no big deal as there is plenty of material.
Le Mans Master
Joined: May 2003
Posts: 5,362
Likes: 3
From: Delray Beach FL
Re: PLUG WIRING????????? (65Z01)
This weekend must be tune up day. I am replacing my plugs and wires as well. I got a set of R&M wire dividers to install on my 93 with the MSD 8.5mm wires. I had the red anodized finish replaced with a white powder coat. I want them to stand out and the red wires should look really good in them! :smash:
Le Mans Master
Joined: Jun 2002
Posts: 6,097
Likes: 0
From: High Plains Drifter Fayetteville, AR
Re: PLUG WIRING????????? (justatoy)
I used MSD looms from autozone. They don't attach to the engine directly. I just loomed them over the valve covers and dropped them down to each plug. $9
