Shift Code 36..........HELP..........
Le Mans Master
Joined: Aug 2003
Posts: 9,884
Likes: 3
From: Magnolia Mississippi
St. Jude '03-'04-'05-'06-'07
Re: Shift Code 36..........HELP.......... (C4Fanatic)
Code 36 is MAF Burn Off Function Fault: Replace the 2 relays behind the battery (PN: 14089936) - both are the same relays: Got mine at Autozone for $7.59 each... The disconnect neg cable to reset codes... :thumbs:
Thread Starter
Safety Car
Joined: Jan 2003
Posts: 4,915
Likes: 6
From: Andover, KS
Re: Shift Code 36..........HELP.......... (C4Fanatic)
More info: this is on a 4+3 car and shows up as a transmission fault, code 36"shift fault". It's not showing up as the MAF fault.
Le Mans Master
Joined: Jan 2003
Posts: 5,858
Likes: 7
From: Santa Maria CA
Re: Shift Code 36..........HELP.......... (C4Fanatic)
I just went through the same thing the other day with my 86 Automatic. I scanned my vette with my Auto X Ray scannner and got "transmission shift fault." Then I grounded the two upper right hand terminals of the under dash connector. It flashed me a CODE 36. What are you using to pull the code and the "transmission shift fault"?
I then cleared the CODE 36 . CODE 36 is Mass aif flow burn off circuit. How are you pulling the code?
Go to this website http://www.c4vettes.com/ecm.htm
Scroll down and you will see tables with the codes and their most common cures.
BEFORE you replace the MAF sensor relays do this.
Go to http://www.c4vettes.com/ecm.htm
Complete the following.
Code 36: Check connections at MAF, MAF relay and MAF Burn off relay. Check resistance of MAF relay and MAF burnoff relay with digital Ohm meter. replace if less than 18 Ohms. Possible ECM failure.
I found my MAF relay connections caked with s@#t. I sprayed some electronic connection cleaner spray in there, disconnected the battery for a while, and WHALA. Code 36 cleared. Hope this helps you man.
:thumbs: :thumbs: :auto:
[Modified by 86PACER, 12:54 AM 12/21/2003]
I then cleared the CODE 36 . CODE 36 is Mass aif flow burn off circuit. How are you pulling the code?
Go to this website http://www.c4vettes.com/ecm.htm
Scroll down and you will see tables with the codes and their most common cures.
BEFORE you replace the MAF sensor relays do this.
Go to http://www.c4vettes.com/ecm.htm
Complete the following.
Code 36: Check connections at MAF, MAF relay and MAF Burn off relay. Check resistance of MAF relay and MAF burnoff relay with digital Ohm meter. replace if less than 18 Ohms. Possible ECM failure.
I found my MAF relay connections caked with s@#t. I sprayed some electronic connection cleaner spray in there, disconnected the battery for a while, and WHALA. Code 36 cleared. Hope this helps you man.
:thumbs: :thumbs: :auto:
[Modified by 86PACER, 12:54 AM 12/21/2003]
Le Mans Master
Joined: Jan 2003
Posts: 5,858
Likes: 7
From: Santa Maria CA
Re: Shift Code 36..........HELP.......... (vinnies87)
:seeya :iagree:
If I did not have a digital multimeter, I would have just paid the $15 to rule out that possibility. Not a lot of money. :D If you do not have a multimeter, sure, consider just replacing them for $15, why not? :D
Vinnies87,
I did not intent any contraversy. :thumbs: :D
[Modified by 86PACER, 12:55 AM 12/21/2003]
If I did not have a digital multimeter, I would have just paid the $15 to rule out that possibility. Not a lot of money. :D If you do not have a multimeter, sure, consider just replacing them for $15, why not? :D
Vinnies87,
I did not intent any contraversy. :thumbs: :D
[Modified by 86PACER, 12:55 AM 12/21/2003]
Le Mans Master
Joined: Aug 2003
Posts: 9,884
Likes: 3
From: Magnolia Mississippi
St. Jude '03-'04-'05-'06-'07
Re: Shift Code 36..........HELP.......... (86PACER)
Hey, none taken here, just was thru this code already... and fround one bad, and since the work together, its (to me that is) a safer bet to replace them both, that was my point.... :cheers: :thumbs:
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Top 10 Corvette Engines RANKED by Peak Torque (70+ Years of Muscle!)
Joe Kucinski
Corvette ZR1X Will Be Pacing the Indy 500, And Could Probably Race, Too!
Verdad Gallardo
Top 10 Corvettes Coming to Mecum Indy 2026!
Brett Foote
Top 10 C9 Corvette MUST-HAVES to Fix These C8 Generation Flaws!
Michael S. Palmer
10 Revolutionary 'Corvette Firsts' Most People Don't Know
Joe Kucinski
5 Reasons to Upgrade to an LS6-Powered Corvette; 5 Reasons to Stay LT2
Michael S. Palmer
2027 Corvette vs The World: Every C8 vs Its Closest Competitor
Joe Kucinski
10 Most Common Corvette Problems of the Last 20 Years!
Joe Kucinski
Thread Starter
Safety Car
Joined: Jan 2003
Posts: 4,915
Likes: 6
From: Andover, KS
Re: Shift Code 36..........HELP.......... (vinnies87)
Thanks for the help guys and the directions to that website. Save to favorites, it will come in handy.
Unfortunately, I get to use it on my car now :banghead: driving around town today I got a SES light and she started running like shiznit, so it's in the garage waiting for me to come pull the codes. :banghead: :banghead:
That's what I get for parking it next to the 88 with the code 36, damn virus jumped over and infected my car. :lol:
Unfortunately, I get to use it on my car now :banghead: driving around town today I got a SES light and she started running like shiznit, so it's in the garage waiting for me to come pull the codes. :banghead: :banghead:
That's what I get for parking it next to the 88 with the code 36, damn virus jumped over and infected my car. :lol:
