Preparing for a TPiS LT header installation
Thread Starter
Pro
Joined: Sep 2003
Posts: 588
Likes: 8
From: Tampa Fl
Preparing for a TPiS LT header installation
The 'vette's a 1990 and I JUST got my new toys in the mail the other day. I was interested in any tips and tricks you guys can give me before I start pulling her apart. Also, how long does the usual installation take? Thanx! :thumbs:
Team Owner
Joined: Sep 2003
Posts: 25,295
Likes: 4
From: I'm the walkin dude I can see all of the world...
St. Jude Donor '03
Re: Preparing for a TPiS LT header installation (VB Black Ice)
Its gonna take a little while. Especially if you haven't ever pulled the manifolds before. Get some cold beer and a friend because some of these bolts are hard to get to and some are rusty and dont want to move. Start early in the weekend. :yesnod: Good luck :cheers:
Thread Starter
Pro
Joined: Sep 2003
Posts: 588
Likes: 8
From: Tampa Fl
Re: Preparing for a TPiS LT header installation (VictorRussell'92)
I've got access to a frame lift and all the pneumatic toys my heart desires for the time bieng so the rust shouldn't be that bad :smash:
Team Owner
Joined: Sep 2003
Posts: 25,295
Likes: 4
From: I'm the walkin dude I can see all of the world...
St. Jude Donor '03
Re: Preparing for a TPiS LT header installation (VB Black Ice)
Thats Great! You lucky Bastich! :lol: Then a few things to look out for is the oil dip stick, starter motor, spark plugs, knock and any other sensors, and I think TPIS has an issue with the Y-pipe. Pretty sure with auto's. I dont know anything about it tho. :yesnod:
Team Owner
Joined: Dec 2000
Posts: 90,675
Likes: 304
From: SE NY
Cruise-In II Veteran
Re: Preparing for a TPiS LT header installation (VB Black Ice)
I agree, put some Liquid Wrench or Blaster on the Y-pipe bolts over night before starting.
I've heard that the gas lines need to be moved slightly where they cross the frame.
I've heard that the gas lines need to be moved slightly where they cross the frame.
Burning Brakes
Joined: Feb 2003
Posts: 1,212
Likes: 0
From: OH
Re: Preparing for a TPiS LT header installation (65Z01)
I just started my process. I should have my headers delivered tomorrow. Those Y-pipe nuts are not too bad with an impact wrench and lots of PB Blaster. Still have one on the passanger side that I can't get off, only can fit a 3/8" ratchet and just too rusted still, so soaking it overnight.
