Cylinder head problems
Thread Starter
Drifting
Joined: Jun 2001
Posts: 1,625
Likes: 1
From: Zagreb, Croatia
Cylinder head problems
Last year I installed cam and other stuff ( see sig ).
Before a few days I took down rockers to install valve seals
what I didn't do before, and I saw that rockers were rubbing
on retainers.
I have ordered CC's 1.6 RR's and problem solved. At least that's
what I have thought.
But the new and even bigger problem is that I don't have enough clearance
between O'ring seals and lower seals. :banghead:
Only solution that I see so far is to take cylinder heads down again
put in new valves, new valve seats, new guides......new head gaskets.......
But that is too much time and MONEY.
:nonod: :nonod: :nonod:
Before a few days I took down rockers to install valve seals
what I didn't do before, and I saw that rockers were rubbing
on retainers.
I have ordered CC's 1.6 RR's and problem solved. At least that's
what I have thought.
But the new and even bigger problem is that I don't have enough clearance
between O'ring seals and lower seals. :banghead:
Only solution that I see so far is to take cylinder heads down again
put in new valves, new valve seats, new guides......new head gaskets.......
But that is too much time and MONEY.
:nonod: :nonod: :nonod:
