need help !
Race Director
Joined: Sep 2000
Posts: 17,298
Likes: 33
From: The Top of Utah
Re: need help ! (crznstyl)
With all due respect, if that is as far as the two of you can get, you're going to need a factory service manual. Try here: http://www.helminc.com
Good luck, and...
RACE ON!!!
Good luck, and...
RACE ON!!!
Team Owner
Joined: Dec 2000
Posts: 90,675
Likes: 304
From: SE NY
Cruise-In II Veteran
Re: need help ! (crznstyl)
I believe on a '95 or later you need a scan tool to pull codes or at least the ALDL differs from the earlier 12-pin setup.
Maybe someone with a '95 will drop in.
Maybe someone with a '95 will drop in.
Le Mans Master
Joined: Jul 2002
Posts: 5,818
Likes: 2
From: Alive and well in Burlington NC
Re: need help ! (crznstyl)
There are a few threads around about this topic. Here is one with some info:
http://forums.corvetteforum.com/zero...328#1546929328
http://forums.corvetteforum.com/zero...328#1546929328
Le Mans Master
Joined: Oct 2003
Posts: 6,130
Likes: 2
From: seattle WA
Re: need help ! (Steel Blue 91)
Yep :iagree: ,but you might try disconnecting the battery for a few minutes-it may reset. You might want to check this site http://www.c4vettes.com/ecm.htm
Good Luck ;)
Good Luck ;)
Large Impressive Member
Joined: Jul 2003
Posts: 65,811
Likes: 71
From: Good health is merely the slowest possible rate at which one can die
St. Jude Donor '04-'05-'06-'07
Re: need help ! (crznstyl)
You can flash the codes w/ the 12 pin set-up and the book says it could have either one, but my 95 has the 16 pin and requires the tool.
