Clunk...thunk..PART III. A question
Thread Starter
Race Director
Joined: Jan 2000
Posts: 16,488
Likes: 25
From: USA. Northern Virginia
Clunk...thunk..PART III. A question
I ordered my new poly bushings and spring pads for the rear of my "94" this morning.
My question is: Are these bushings for the control arms "pressed in" or are they just a "very snug fit"?
Thanks
My question is: Are these bushings for the control arms "pressed in" or are they just a "very snug fit"?
Thanks
Thread Starter
Race Director
Joined: Jan 2000
Posts: 16,488
Likes: 25
From: USA. Northern Virginia
Originally Posted by bogus
I would have to think somewhere in between. I have not done this yet, but I think a vice would be in order.
You will need a torch to burn out the old rubber pieces.
You will need a torch to burn out the old rubber pieces.
...I might have to get a few Corvette buddies over for this event 
