So, when is Paul making an 8 sec pass
#121
#122
Watch "Quickvertc5 at atco.1.27 60 foot" on YouTube
#124
ISIS SUCKS FAT CHOAD
#126
Hey mvp whatever your name is...
We're is your video?.
We're is your car?
Do u even own a vette?
That avatar is NOT a vette
Only thing I see is your rusty used parts in saw u were selling
U seem to know everything...
We're is your video?.
We're is your car?
Do u even own a vette?
That avatar is NOT a vette
Only thing I see is your rusty used parts in saw u were selling
U seem to know everything...
#127
#128
Team Owner
Member Since: Jan 2007
Location: cookeville tennessee
Posts: 28,846
Received 1,762 Likes
on
1,529 Posts
Paul, Mike just told you good job here. Then you come off with crap like this on a man. Do you may think this is part of the reason some of the guys in here hide your azz so much on stuff..
#129
ISIS SUCKS FAT CHOAD
The following users liked this post:
MVP'S ZO6 (10-24-2015)
#131
why i had to post videos and timeslips is beyond me...
btw that pass i was at 60% throttle on my log lmao
The following users liked this post:
MVP'S ZO6 (10-24-2015)
#132
Drifting
I'm just amazed that a stock suspension vette did a sub 1.30 60ft. Well done man. From what I've read you're quite the polarizing figure on the forum, but I could honest give two *****'s.
I'm just blown away at the lack of safety equipment in that thing and that any track owner would let it down the strip past the first run. Regardless, hope you stay safe.
- Travis
I'm just blown away at the lack of safety equipment in that thing and that any track owner would let it down the strip past the first run. Regardless, hope you stay safe.
- Travis
#133
Le Mans Master
Car still ran its fastest with Doug's ECS tuning, I bet your trans would still be good and you would have seen your 8s pass If you would have just not Burt all your bridges...........
#134
there is no burnt bridges here man...I use ecs parts in my car and will continue to do so
now were is your car...???
most of u dont know how to even change oil...i built this car MYSELF
this is why i started my own corvette page..all u clowns are out of it and i will make sure of it
this does not happen on my page and i run it nice and clean
Last edited by blown81bu; 10-24-2015 at 09:21 PM.
#135
I'm just amazed that a stock suspension vette did a sub 1.30 60ft. Well done man. From what I've read you're quite the polarizing figure on the forum, but I could honest give two *****'s.
I'm just blown away at the lack of safety equipment in that thing and that any track owner would let it down the strip past the first run. Regardless, hope you stay safe.
- Travis
I'm just blown away at the lack of safety equipment in that thing and that any track owner would let it down the strip past the first run. Regardless, hope you stay safe.
- Travis
we are doing a bar in it over the winter so maybe good i didnt make full pass yet it pulls insane up top
Last edited by blown81bu; 10-24-2015 at 09:22 PM.
#137
#138
Le Mans Master
how do u know?
there is no burnt bridges here man...I use ecs parts in my car and will continue to do so
now were is your car...???
most of u dont know how to even change oil...i built this car MYSELF
this is why i started my own corvette page..all u clowns are out of it and i will make sure of it
this does not happen on my page and i run it nice and clean
there is no burnt bridges here man...I use ecs parts in my car and will continue to do so
now were is your car...???
most of u dont know how to even change oil...i built this car MYSELF
this is why i started my own corvette page..all u clowns are out of it and i will make sure of it
this does not happen on my page and i run it nice and clean
#139
Melting Slicks
#140
ISIS SUCKS FAT CHOAD
I got 20 that says he was over 60% throttle. Any takers? He must think we're not intelligent!
Waiting on the attempt to post a still shot of a data log!
Waiting on the attempt to post a still shot of a data log!
Last edited by MVP'S ZO6; 10-25-2015 at 12:01 AM. Reason: Edited for the sake of CF Rules and to not hurt anyone's feelings.