How Do You Install Clear Corner Lights?
Thread Starter
Racer
Joined: Mar 2005
Posts: 365
Likes: 0
From: Hanover Pennsylvania
How Do You Install Clear Corner Lights?
I'm not sure exactly how to remove the factory front corner lights, and replace them with the clear ones. Any tips or instructions would help alot. TIA, Jason 
Race Director
Joined: Feb 2004
Posts: 11,651
Likes: 9
From: HOW FAST WAS I GOING OFFICER? Los Angeles Hating GM Dealership Service Dept.'s Since Sept. 2004
St. Jude Donor '04-'05-'06-'07
Rhino ramp the front end. Chuck the wheels and set e-brake.
Remove the two smaller parts of the air damn from each side. There are a couple of small bolt screws for each side.
Look into nose area. Unhook the spring holding the lights in place ... do one side first so you can refer to the other for orientation if needed.
Remove 3-4 other bolt screws mounting the lights to a base in the nose.
I believe the bolt screws are 5mm or so.
Remove the two smaller parts of the air damn from each side. There are a couple of small bolt screws for each side.
Look into nose area. Unhook the spring holding the lights in place ... do one side first so you can refer to the other for orientation if needed.
Remove 3-4 other bolt screws mounting the lights to a base in the nose.
I believe the bolt screws are 5mm or so.
