Remote Question
Thread Starter
Advanced
Joined: Jun 2005
Posts: 77
Likes: 0
From: Cookeville TN
Remote Question
Both of my remotes are set with the passive turned OFF. But one still works as passive even though it is turned off. I have reset both but the one still locks and unlocks by itself, even though it is switched to the off position. Does anyone know why this is?
Team Owner
Joined: Aug 2002
Posts: 35,617
Likes: 167
Tech Contributor
Cruise-In 11 Veteran
NCM Ambassador
St. Jude Donor '05-'06-'07-'10
Originally Posted by BlackC5Vette
You may want to try the switch 2-3 times (flick it to on and then off again) and that should send the signal to the circuit board. I'm guessing it didn't contact the first time you did it. 
That should do the trick. The little switch gets dirty and the contacts get funny on them.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Top 10 Corvette Engines RANKED by Peak Torque (70+ Years of Muscle!)
Joe Kucinski
Corvette ZR1X Will Be Pacing the Indy 500, And Could Probably Race, Too!
Verdad Gallardo
