Brake Light
Oct 17, 2006 | 10:14 PM
Thread Starter
3rd Gear
Joined: Oct 2006
Posts: 3
Likes: 0
Brake Light
I have a 2000 Coupe and the brake light is not working. I would like to change it myself but I can't figure out how to gain access to the light. It doesn't appear to be accessible from the inside, and there are no screws on the outside. Is there any help out there?
Oct 17, 2006 | 10:21 PM
Safety Car
Joined: Feb 2004
Posts: 4,208
Likes: 2
From: Rochester MN
CI 5-6-7-8 Veteran
St. Jude Donor '04-'05-'06-'07
NCM Ambassador
If you're trying to get at the 3rd brake light, you need to take one of the inner regular brake lights out and reach in behind the 3rd light.
Oct 21, 2006 | 11:06 AM
Thread Starter
3rd Gear
Joined: Oct 2006
Posts: 3
Likes: 0
Brake Light
I did as suggested and gained access to the 3rd brake light but can't get it loose from it's clip. Any suggestions? Thanks.
Oct 21, 2006 | 11:20 AM
Race Director
Joined: Apr 2001
Posts: 19,329
Likes: 15
From: Saint Augustine, FL
Mid-TN Events Coordinator
St. Jude Donor '03-'04-'05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
Here's the replacement directions direct from the service manual :
Remove one of the inner tail lamps. Refer to Tail Lamp Replacement . Access the high-mounted stop lamp through the tail lamp opening.
Disconnect the electrical connector from the stop lamp.
Remove the screws retaining the stop lamp to the rear fascia.
Remove the stop lamp from the vehicle through the tail lamp opening.
According to the diagram, there are 2 screws holding the 3'rd light. They are screwed in from below the light if that helps.
Oct 21, 2006 | 11:46 AM
Instructor
Joined: Jan 2004
Posts: 175
Likes: 0
From: Loughborough, UK
According to the diagram, there are 2 screws holding the 3'rd light. They are screwed in from below the light if that helps.[/QUOTE]
I beleive that there are two bolts are on the bottom of the bracket, 7mm from what I remember??
Oct 21, 2006 | 07:26 PM
Thread Starter
3rd Gear
Joined: Oct 2006
Posts: 3
Likes: 0
Thanks for the help.
Quote:
Originally Posted by sleddspi
I did as suggested and gained access to the 3rd brake light but can't get it loose from it's clip. Any suggestions? Thanks.
Thanks for the help. The first thing I did was check the connection and that solved the problem. I had just come "unplugged".