Front signal lamp assembly
Pro
Joined: Mar 2004
Posts: 640
Likes: 0
From: Waddell Arizona
removed front light assemblies
I just change my front light assemblies this past weekend. I jack the vehicle up and installed a jack stand. Then I removed the front wheel, right below the brake duct there is a panel that has 4 screws(mine had 4 screws).After removing the panel you have to remove the brake air duct, I think that is the is the hardness part. I push the duct forward and down. After removing it the light assembly is accessable. Two screws hold the assembly in. One is a hex head (10mm) and the other is the same type to remove the access panel. After removing assembly you see two other screws holding the light assembly to the bracket.
Gary
Gary
Last edited by grunz95; Apr 17, 2007 at 08:34 PM.
Instructor
Joined: Dec 2006
Posts: 173
Likes: 1
From: Brandon MS
way to much work, all I did was put the car on ramps, undo 3 or 4 screws from the bottom back of the bumper and reach up and twist and pull the light out and replace the bulb. Takes longer to put the tools and ramps up then to do the work.
