Header install help
Thread Starter
Racer
Joined: Jan 2006
Posts: 394
Likes: 0
From: Lawrenceburg IN
Header install help
The headers, xpipe and exhaust are going on tomorrow. The only part I'm sweating installing are the headers. Can anyone offer advice or have a link to a step by step for header removal and installation? This will be done on jack stands, not a lift so I'm sure that will throw some added fun my way! Any tips will be helpful and appreciated. Thanks in advance.
Pro
Joined: Jul 2004
Posts: 500
Likes: 1
From: Anna Ohio
here's a link to Cajundude's LGM long tube header install. Good luck! 
http://www.cajundude.com/longtubes.htm
wanna do mine next?
http://www.cajundude.com/longtubes.htm
wanna do mine next?
Last edited by Berger6696; Jun 19, 2008 at 04:15 PM.
Melting Slicks
Joined: Mar 2006
Posts: 2,997
Likes: 36
From: Ocean Springs MS
I did mine on jack stands, installed AR headers and wasn't bad at all. Just took my time and if ran into an obstacle just took a step back for a few minutes and then tried again. I do highly suggest only loosely bolting them to the heads until you get the x-pipe bolted up too. Good luck.
Race Director
Joined: Jul 2004
Posts: 16,795
Likes: 62
From: Lake Havasu City, AZ
Thread Starter
Racer
Joined: Jan 2006
Posts: 394
Likes: 0
From: Lawrenceburg IN
I'm going with the Dynatech supermaxx headers. They look great sitting next to the car! It looks a little daunting but the write ups you guys posted will be a tremendous help no doubt. Thanks a million!
Le Mans Master
Joined: Nov 2006
Posts: 7,021
Likes: 46
From: enterprise al
St. Jude Donor '08
... make sure the car is safe and secure on them jackstands! take ur time and dont try to force anything.. when you get frustated and start tearing up your knuckles, sit back and have a beer
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Thread Starter
Racer
Joined: Jan 2006
Posts: 394
Likes: 0
From: Lawrenceburg IN
Drifting
Joined: Oct 2005
Posts: 1,435
Likes: 0
From: Saint Louis MO
Other than that they fit perfectly. Follow the instructions that Dynatech sent with the headers and you'll be fine. If you have any other questions feel free to PM me.
