[Z06] Lots of BS here on CAI--would people be honest
03-05-2012, 06:03 PM
#22
Melting Slicks
Member Since: Apr 2010
Posts: 3,203
Likes: 0
Received 0 Likes
on
0 Posts
03-05-2012, 07:25 PM
#25
Racer
Member Since: Nov 2009
Location: Cypress Texas
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
You guessed it my friend. First, make sure the hole that you cut lines up with the Blackwing, second, make points in the same diameter as the Blackwing, remove the shroud, cut the opening with a sawzall or whatever cuts through the shroud the easiest, then of course, re-install the shroud. Immediate performance increase, lower engine temps, more power. Its all good.Also SAVE BIG BUCKS
03-06-2012, 06:53 PM
#27
Melting Slicks
This is the best bang for the buck!! http://www.vorteccyclone.com/boosthorsepower.html
Hell yea, I found a way to put 4 of them in and have like 1000hp, dude!
03-06-2012, 08:45 PM
#29
Melting Slicks
Biggest bang for buck? Or free? Flip tie.
I had a blackwing on my car. My car ran good for what it was, never did try a fancy VR but the fastest bolt-on c5z ran it so i'm sure it's doing something good.
I had a blackwing on my car. My car ran good for what it was, never did try a fancy VR but the fastest bolt-on c5z ran it so i'm sure it's doing something good.
03-06-2012, 09:14 PM
#30
I did a direct comparison between the new Halltech Killer Bee II C5 conversion and my old Breathless Performance system. Car has all the mods in my sig, both systems were tested and tunes optimized on the dyno. Tested the Breathless system first, swapped in the Halltech system adusted the tune and picked up 5 RWHP and 5 lbft of torque.
Jim
Jim
