pfdat issue HELP
Thread Starter
Pro
Joined: Apr 2010
Posts: 621
Likes: 1
From: westland mi
St. Jude Donor '12
pfdat issue HELP
hello i was wondering if anyone else who used pfdat motor mounts has had this issue? with the pins not lining up and with the way they face one in and one out see pics
thank you
pin not fitting
pins not fiiting
two different directions (yes i am **** about things like this lol)
thank you
pin not fitting
pins not fiiting
two different directions (yes i am **** about things like this lol)
Team Owner
Joined: Jan 2007
Posts: 29,065
Likes: 1,839
From: cookeville tennessee
Could just be a mistake on there part and will replace them for you. Great CO. to deal with from all the parts I have of PFADT on my car. Give them a call tomorrow and send them a pic,s of the problem.. Robert
Last edited by robert miller; Oct 29, 2012 at 10:06 PM.
Safety Car
Joined: Dec 2009
Posts: 3,724
Likes: 9
There is a very simple fix to both your problems, just as we emailed you yesterday. That alignment pin is simply an installation tool, takes absolutely no load, and is just pressed into the orange housing. Given that you've got the entire subframe removed and no engine installed you aren't going to need that alignment pin. Pull the pin out of the orange housing and flip the mount around 180 degrees. You will see absolutely no detrimental effects on performance or longevity by removing the pin. Occasionally the position of the hole in the factory subframe can be a little off, the pin is just there to make the mount a little easier to install but it absolutely does not have to be there for the mount to function properly.
This solution fixes both of your problems. The mount will now sit flush onto the subframe so you can properly bolt it up, and the laser etched Pfadt logos are now turned the same direction.
If you have any questions please let me know. My email address is jarrett@pfadtracing.com, or you can reach me at 1-888-972-2464.
This solution fixes both of your problems. The mount will now sit flush onto the subframe so you can properly bolt it up, and the laser etched Pfadt logos are now turned the same direction.
If you have any questions please let me know. My email address is jarrett@pfadtracing.com, or you can reach me at 1-888-972-2464.
