When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So I had some old LS1 fuel rail covers which I refurbished. I want to do some type of wall art featuring the covers with the Intake in the middle. Anyone have any suggestions on how I would go about getting a junk intake and somehow slicing the top off to lay flat in between the covers? Picture kind of shows what I'm going for (a top view for my wall).
As these guys said above, band saw would be great. Maybe bolt the intake to a jig holding it square so you're not freehanding it sliding it through the saw.
Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette
Slideshow: A Jaguar designer's personal project imagines what a modern front-engined Corvette might look like if Chevrolet revisited the golden age of the Stingray.
Strange Question
a band saw would cut right through the intake .
