etp 245s 62cc heads
04-19-2006, 02:18 PM
#1
Melting Slicks
Thread Starter
etp 245s 62cc heads
I just installed them,they have less than 200 miles on them. No problems at all! Perfect condition
245 runners
62 cc chambers
2.08/1.6 valves
11 degree
asking $2500.
thanks
J
here the original thread.
http://www.ls1tech.com/forums/showt...33&page=1&pp=20
245 runners
62 cc chambers
2.08/1.6 valves
11 degree
asking $2500.
thanks
J
here the original thread.
http://www.ls1tech.com/forums/showt...33&page=1&pp=20
04-21-2006, 06:46 AM
#4
Melting Slicks
Thread Starter
They have the dual springs, good to .650 lift.
I'm selling cause I'm going to a different setup. They are beautiful heads. I still have them on the car, drove it the 80 miles (
)to work today
thanks
J
I'm selling cause I'm going to a different setup. They are beautiful heads. I still have them on the car, drove it the 80 miles (
)to work todaythanks
J
04-21-2006, 08:55 AM
#5
Race Director
Who did the installation? I might be interested..
04-25-2006, 06:23 AM
#8
Melting Slicks
Thread Starter
These are flow #'s from an independant shop in MD.
etp 245 4" bore 28"
far left port
int exh
200 147 200 106
300 220 300 159
400 270 400 204
500 310 500 225
600 331 600 236
625 335 700 240
far right port
int exh
200 146 200 106
300 223 300 159
400 272 400 203
500 309 500 225
600 329 600 236
625 334 700 242
etp 245 4" bore 28"
far left port
int exh
200 147 200 106
300 220 300 159
400 270 400 204
500 310 500 225
600 331 600 236
625 335 700 240
far right port
int exh
200 146 200 106
300 223 300 159
400 272 400 203
500 309 500 225
600 329 600 236
625 334 700 242
Last edited by cyclerage23; 04-25-2006 at 07:52 AM.
