hypertech power programmer problem?
Thread Starter
Intermediate
Joined: May 2003
Posts: 48
Likes: 0
From: weston fl
hypertech power programmer problem?
I downloaded the Hypertech tuning into my practically stock 97 C5 A4 on tuesday morning. Nothing to agressive. Mid ranges on everything. I drove it all day tuesday with no problem that i noticed. Tonight as i'm driving up to the grocery store i notice that the oil pressure needle is buried. I check the digital read out and it is at 128psi. I stopped the car immediately and turned it off. The pressure slowly reduces. I just checked it and it is back down 92psi after being in the garage for 20 minutes. When i stopped the car i happened to have the programmer in the car and reinstalled the stock program. No change in the oil pressure problem when i restarted the car. I drove home with no explosions but.......?
Any ideas of what the problem might be?
Any ideas of what the problem might be?
Team Owner
Joined: Apr 2001
Posts: 54,204
Likes: 180
From: S.W. Ohio. . . . . . NRA Life Member
1SLANDON; I noticed you have an A4. Just a note: the Hypertec will not do gear scaling on the C5 (though it works fine on F-Bodies).
Not a problem if you don't intend to change the rear axle ratio.
Not a problem if you don't intend to change the rear axle ratio.
