power duct install question
Thread Starter
Advanced
Joined: May 2003
Posts: 96
Likes: 0
From: ATL ga
power duct install question
Took off the old duct and blackwing this afternoon. I going to clean the blackwing and have already cleaned the TB and maf housing. finding any reason on a day like to day to poke around under the hood.
Anyways here the question. Being a 98 a know I have to drill the hole in the new duct for the IAT, but what do you recommend for the vacum line from the fuel regalator? Put a pin hole in the coupler and put it there? Thats where it was on the original coupler, but I hate to put a hole in it.
thanks
98droptop
Anyways here the question. Being a 98 a know I have to drill the hole in the new duct for the IAT, but what do you recommend for the vacum line from the fuel regalator? Put a pin hole in the coupler and put it there? Thats where it was on the original coupler, but I hate to put a hole in it.
thanks
98droptop
Tech Contributor
Joined: Dec 1999
Posts: 32,910
Likes: 2,402
From: Anthony TX
CI 6,7,8,9,11 Vet
St. Jude Donor '08
I purchased a fuel pressure regulator recalibration kit from Ecklers Corvette Parts. If you use that, you will not have to drill the hole in there.
Bill
Bill
